Drilling Vulcanite Rod: Difference between revisions

Drilling Vulcanite Rod (view source)

153 bytes added , 16 years ago

no edit summary

23,097

edits

Revision as of 23:54, 5 August 2007 (view source) Sethile (talk \| contribs) (New page: I use a Taig micro metal lathe for this operation, so my instruction will be specifically for that lathe, but they should be generic enough to be followed on any metal lathe. 1. Chuck the...)		Revision as of 00:26, 6 August 2007 (view source) Sethile (talk \| contribs) No edit summary Newer edit →
Line 1:		Line 1:
			The basis for the following article was written by [[Tyler Lane]] for his [http://www.tylerlanepipes.com/index.php website], and is used by permission.

	I use a Taig micro metal lathe for this operation, so my instruction will be specifically for that lathe, but they should be generic enough to be followed on any metal lathe.		I use a Taig micro metal lathe for this operation, so my instruction will be specifically for that lathe, but they should be generic enough to be followed on any metal lathe.